Sulky DPX User Manual Page 22

  • Download
  • Add to my manuals
  • Print
  • Page
    / 76
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 21
Chargement
a) Tamis
- Vérifier qu'il n'y ait pas de corps étranger dans la trémie
avant le chargement.
- Bloquer les tamis en position basse.
Ne jamais travailler sans les tamis.
b) L'indicateur de capacité donne la valeur en litre de
produit pour les deux côtés.
c) Chargement
Pour baisser la hauteur de chargement, régler l’attelage du
tracteur de manière à ce que le DPX MAGNUM soit incliné
et repose sur ses béquilles.
Vidange
La machine doit être à l'arrêt.
Démonter les disques d'épandage
Positionner votre DPX haut de la poutre à 40 cm du sol
(appareil horizontal) afin de pouvoir placer votre essai de
débit sous la distribution (d).
Récupérer l'engrais dans votre seau côté droit puis gauche
en agissant manuellement sur le levier de réglage ou sur les
téléflexibles correspondants.
Remonter vos disques en respectant le sens de montage.
Bien resserrer les disques.
H
I
H
I
H
I
Mise en route
Start-up
Inbetriebsetzung
21
FR
GB
DE
Loading
a) Sifting screen
- Check that there are no foreign bodies in the hopper before
loading.
- Secure the sifting screen in the bottom position.
Never use the spreader without the sifting screens.
b) The capacity indicator gives the value in litres of product
for the two sides.
c) Loading
To lower the loading height, adjust the tractor hitch to tip
the DPX MAGNUM on to its parking supports.
Emptying
The machine must be switched off.
Remove the spreading discs
Position your DPX at the top of the beam 40 cm above the
ground (horizontal equipment) so that your calibration test
kit can be placed underneath the metering device (d).
Operate the setting lever or the relevant remote control
cables by hand to collect fertilizer in the bucket, first on the
RH side and then on the LH side.
Refit the spreading discs, making sure they are the right
way round.
Retighten the discs fully.
Laden
a) Siebe
- Vor dem Laden prüfen, ob sich kein Fremdkörper im
Behälter befindet.
- Siebe in unterer Stellung blockieren
Niemals ohne Siebe arbeiten.
b) Inhaltsanzeiger gibt den Wert in Litern/Produkt für beide
Seiten an.
c) Laden
Zum Reduzieren der Ladehöhe die Schlepperkupplung so
einstellen, daß der DPX MAGNUM geneigt ist und auf
seinen Stützen aufliegt.
Entleeren
Nur bei Maschinenstillstand arbeiten.
Streuscheiben abmontieren
DPX in obere Position, in 40 cm Abstand vom Boden
bringen (Gerät horizontal), um die Adrehprobe unter die
Verteilung (d) platzieren zu können.
Dünger durch manuelles Verstellen des Einstellhebels bzw.
an den entsprechenden Bowdenzügen einmal links, einmal
rechts in dem Eimer auffangen.
Streuscheiben anheben, dabei auf die Montageausrichtung
achten.
Streuscheiben wieder gut anziehen.
Page view 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 75 76

Comments to this Manuals

No comments